Drilling Holes On The Support Bench - Astoria Plus4YouTS Use And Maintenance Manual

FOR THE U.S.A.
The water connections and discharges must be
!
made in accordance with the 2003 International
Plumbing Code of the International Code Council
(ICC), or with the 2003 Uniformed Hydraulic Code
of the IAPMO. The machine must be installed
together with an adequate non-return valve, as
required by national regulations.
3.3

Drilling holes on the support bench

In the case where it is necessary to drill holes on the support bench for passing the water inlet and outlet hoses,
as well as the electrical and gas supply cables, follow the directions in the drawings below.
2 GROUPS
3 GROUPS
4 GROUPS
18
200 mm
Front of the machine
536 mm
300 mm
Front of the machine
776 mm
Front of the machine
1016 mm
During the installation of the appliance, only
the components and materials supplied with the
appliance are to be used. Should the use of other
!
components be necessary, the installer must
verify their suitability to be used in contact with
water used for human consumption. The installer
must carry out the hydraulic connections in
accordance with the hygiene norms and the
hydraulic safety norms for environmental
protection in force in the place of installation.
400 mm
Technical manual