Programming; Coffee Doses; Autosteamer - Astoria CORE 200 SAE 2 Gr Use And Maintenance Manual

7.

PROGRAMMING

The machine is programmed by default. Should the
settings need to be modified, proceed as described in
the following paragraphs.

Coffee doses

7.1
• Always programme the right
push-button panel first. This way,
both push-button panels are au-
tomatically programmed. If neces-
sary, programme the left later;
• place the cup under the dispens-
ing spout;
• press the button for at least
5 seconds until the
flashes;
• press the desired dose button, for
example ;
• to confirm the dose, press the
button again;
• repeat this operation for the other
dose buttons;
• when the programming is com-
plete, press the
wait 20 seconds.
The programming of every dose must be
carried out with ground coffee and not with
previously used coffee dregs.
The system automatically exits the
programming mode 20 seconds after the
last operation was carried out.
Do not remove the filter holder from the
dispensing group when coffee is being
dispensed.
Do not insert your fingers or any other objects into the filter holder.
Non inserire nel portafiltro le dita o qualsiasi altro oggetto.
TECHNICIANS' manual
button
button, or

Autosteamer

7.2
• Immerse the steam nozzle in the
milk to be foamy, together with
a thermometer to control the
temperature;
• Press the button for at least
5 seconds until the
flashes;
• Press the Autosteamer
button;
• Check with the thermometer
the temperature of the milk and,
once reached the desired one,
lock the dispensing by pressing
the Autosteamer
• when the programming is com-
plete, press the
wait 20 seconds.
Avoid contact with the hot water nozzle, do
not place your hands or other body parts
near the hot water nozzle tip.
Core200
button
button;
button, or
29
of
54