Turning The Machine On And Off; Turning The Machine On; Turning The Machine Off - Astoria futura +4U User Manual

7

Turning the machine on and off

7.1 Turning the machine on

After the hydraulic and electrical connection has
been performed by the qualified personnel, verify
that all the steam taps are closed.
Turn the ma-
chine on using the
main switch (14)
and follow the in-
dications provided
on the machine's
d i s p l ay, a s d e -
scribed below.
When the machine
is turned on, it per-
forms the functional
test and reports in-
formation regarding
the software installed.
xx-xx-xx : update date
Rx : software revision number;
D.Board x.xx: display card version.
The result O.K. in-
dicates that the ma-
chine is working cor-
rectly.
If the machine fails
the functional test, contact the Technical Support
Service.
W h e n t h e m a -
chine is turned on, it
will activate the mo-
tor pump installed
and begin to fill the
services boiler and the water heaters for the coffee
(present in a number equal to the number of deliv-
ery groups installed on the machine.)
38
14
FUNCTIONAL TEST
DELN xx-xx-xx Rx
D.Board x.xx
TEST
-O.K.-
0.0 Bar Press 3.5
08:30 10-MAY-2010
COFFEE
WATER FILLING
In order to bleed
any air present in the
heaters, each time the
machine is turned on
the solenoid valves
of the groups will be activated, making water and
steam come out from the perforated disk of each
group for about 10 seconds.
When the heating
phase of the delivery
groups has finished
(after about 10 min-
utes), signalled by
the disappearance of the "PLEASE WAIT" indication,
it will be possible to make the coffee selections. For
the dispensing of hot water and steam, it will be
necessary to wait for the complete heating of the
services boiler.
During the heat-
ing phase of the
services boiler (from
95°C to 98°C), the
machine will execute
a light delivery of water and steam from the hot
water nozzle.
The dispensing of
steam and hot wa-
ter, and thus the full
operation of the ma-
chine, will be possi-
ble only at a pressure greater than 0.6 bar.
To avoid the risk of burns, it is advisable to
!
keep hands away from the hot water nozzle,
steam nozzle and delivery groups during the
machine's heating phase.
Before using the machine, run deliveries dry with
i
the filter holder attached for a few seconds to
release any air which may be in the circuit, so that
the delivery groups are completely heated.

7.2 Turning the machine off

To turn the machine off, just use the main
switch.
0.0 Bar Press 0.0
08:30 10-MAY-2010
MAKE ATTENTION
WATER/STEAM ESCAPE
0.0 Bar Press 0.0
WAIT PLEASE
Humidity 62% P 32%
0.0 Bar Press 0.0
STEAM ESCAPE
Humidity 62% P 32%
0.7 Bar Press 0.0
08:30 10-MAY-2010
Humidity 62% P 32%
User manual