Figure 9: 5881Enh(C) Rf Receiver (Cover Removed); Figure 10: 5883 Rf Receiver (Cover Removed) - Honeywell VISTA-128BPT Installation And Setup Manual

5883H High Wireless Receiver
Addressing and Bidirectional Setup
Installation of this module is necessary only if you are using a 5800 series wireless bi-directional device.
The address for the Transmission Module must be enabled in the control's Device Programming in the
#93 Menu Mode as a keypad and then assigned to a partition
1. Mount the receiver, following the advisories stated previously.
2. Connect the module's wire harness to the keypad terminals (6, 7, 8, and 9). Plug the connector at the
other end of the harness into the module.
3a. Using dipswitches 2-4 set the module for the appropriate address.
Make sure the address setting is not being used by another device (keypad, relay module, etc.).
3b. Enable bidirectional status by turning dipswitch 6 on.

Figure 9: 5881ENH(C) RF Receiver (Cover Removed)

Figure 10: 5883 RF Receiver (Cover Removed)

SECTION 4: INSTALLING THE CONTROL
.
4-7