Mounting And Wiring The Control; Cabinet And Lock; Mounting The Pc Board Alone (No Rf Receiver) - Honeywell ADEMCO VISTA-10P Installation And Setup Manual

Mounting and Wiring the Control

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

Cabinet and Lock

1. Mount the control cabinet to a sturdy wall in a clean, dry area, which is not readily accessible to
the general public, using fasteners or anchors (not supplied) with the four cabinet mounting
holes.
2. Remove cabinet door, then remove the lock knockout from the door. Insert the key into the lock.
3. Position the lock in the hole, making certain that the latch will make contact with the latch
bracket when the door is closed. When correctly positioned, push the lock until it is held securely
by its snap tabs.
NOTES
• The cabinet can be closed and secured without a lock by using 2 screws in the cover's edge.
Mounting the PC Board Alone
1. Hang two short mounting clips (provided) on the raised cabinet tabs (see Detail B in Fig. 2).
2. a. Insert the top of the circuit board into the slots at the top of the cabinet. Make sure that the
board rests on the correct row (see Detail A).
b. Swing the base of the board into the mounting clips and secure the board to the cabinet with
the accompanying screws (see Detail B).
NOTES
• Before installing the cabinet's contents, remove the metal cabinet knockouts required for wiring
entry. Do not remove the knockouts after the circuit board has been installed.
CIRCUIT
BOARD
DETAIL A
SIDE VIEW
OF BOARD
SUPPORTING
CHECK
POSITION
LOCKED
PUSH
UNLOCKED
CABINET DOOR
BOTTOM
Figure 1. Installing the Cabinet Lock
(no RF Receiver)
CABINET
SLOTS
Figure 2. Mounting the PC Board
SNAP
IS SEATED
TAB
SECURELY
SNAP
TAB
STEP 1 STEP 2
+ +
S E C T I O N
PUSH
ON LOCK
UNTIL IT
CIRCUIT
CABINET
BOARD
DETAIL B
SIDE VIEW
OF MOUNTING
CLIPS
MOUNTING-001-V0
2
2-1