Section 8 : User Codes; General Information; User Codes & Levels Of Authority - Honeywell VISTA-128BPT Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

General Information

The VISTA-128BPT allows a total of 150 security access codes to be allocated. The VISTA-250BPT allows a total of 250
security access codes to be allocated. Each security access code is identified by a user ID number. Regardless of the
number of partitions each code has access to, it occupies only one user slot in the system. If a code is not used in
all partitions, that user ID number cannot be used again.
The Quick Arm feature can also be programmed (partition-specific program field ∗29). The Quick Arm feature allows
the user to arm the system by pressing the [#] key instead of the security code. The security code must always be
entered to disarm the system.
A user code other than the installer code must be programmed in order for the Quick Arm feature to
function.
The system is shipped with the following defaults for the user codes:
User 4-Digit Code
User 1 (Installer) 4140
User 2 1234
User Codes & Levels of Authority
Each user of the system can be assigned a level of authority, which authorizes the user for certain system functions. A
user can have different levels of authority within different partitions
Use the "View Capabilities" keypad function (User Code + [∗] + [∗]) to view the partitions and authority levels for which a
particular user is authorized. These levels are described below.
Level 0: Installer (User 1) Code
• Programmed in field ∗00 (default = 4-1-4-0).
Installer Open/Close reporting selected in field
∗39.
•
Can perform all system functions (arm, disarm,
bypass, etc.), but cannot disarm if armed by
another code (or by Quick Arm).
•
Can add, delete, or change all other codes, and
can select Open/Close reports for any user.
•
Is the only code that can be used to enter
program mode. The Installer Code can be
prevented from re-entering the Program Mode
by exiting using ∗98.
•
Must program at least one Master Code during
initial installation. Master Codes are codes
intended for use by the primary user(s) of the
system.
Alpha
Descriptor
INSTLR
MASTER
Level 1: Master Codes
8-1

Section 8 : User Codes

•
Can perform all normal system functions.
•
Can be used to assign up to 148 lower-level
codes, which can be used by other users of the
system.
•
Cannot assign anybody a level of 0 or 1.
•
May change own code.
•
Can add, delete, or change Manager or Operator
Codes. Each user's code can be individually
eliminated or changed at any time.
•
Open/Close reporting is automatically the same
as that of the Master who is adding the new
user.