Installing The Rf Receiver; Installing A 5800Tm Module - Honeywell Ademco Vista-12D Installation And Setup Manual

Installing the RF Receiver

Use one of the following receivers:
RF Receiver Number of Zones
5881ENL up to 8 (including keyfob
buttons)
5881ENM up to 16 (including keyfob
buttons)
1. Set Device Address to "00" as described in its
instructions (set all switches to the right, "off"
position).
2. Mount the receiver, noting that the RF receiver
can detect signals from transmitters within a
nominal range of 67m.
3. Connect the receiver's wire harness to the
control's keypad terminals. Plug the connector
at the other end of the harness into the
receiver. Refer to the installation instructions
provided with the receiver for further
installation procedures regarding antenna
mounting, etc.
Figure 8. 5881EN RF Receiver (cover removed)

Installing a 5800TM Module

1. Mount the 5800TM next to the RF receiver
(between one and two feet from the receiver's
antennas) using its accompanying mounting
bracket. Do not install within the control
cabinet.
2. Connect the 5800TM to the control panel's
keypad connection terminals as shown on the
Summary of Connections diagram and set to
address 28.
Mounting and Wiring the Control
Notes
• The receiver is supervised and a trouble
report is sent ("CHECK 100" displayed) if
communication between the panel and
receiver is interrupted, or if no valid RF
signals from at least one supervised
transmitter are received within 12 hours.
• Only one receiver can be installed in a system.
If the receiver is mounted remotely:
• Place the RF receiver in a high, centrally
located area for best reception.
• Do not locate the receiver or transmitters on
or near metal objects. This will decrease
range and/or block transmissions.
• Do not locate the RF receiver in an area of
high RF interference (indicated by frequent
or prolonged lighting of the LED in the
receiver; random flicker is OK).
• Do not locate RF receiver closer than 3m
from any keypads to avoid interference from
the microprocessors in those units.
WIRELESS ZONE NUMBERS
transmitter zones 9-24
button or transmitter zones 49-64
Notes
• Use this module only in 345Hz RF systems
and if you are using one or more wireless bi-
directional keypads or keyfob; 5800TM is not
necessary if using a Transceiver (e.g., 5883).
• The 5800TM must be set to address 28 (cut
red-W1 jumper).
• The 5800TM can be used in partition 1 only.
• For additional information regarding the
5800TM, refer to the 5800TM's instructions.
2-11