Section 15 : Contact Id Codes; Table Of Contact Id Codes - Honeywell VISTA-128BPT Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

Table of Contact ID Codes

Code Definition
110 Fire Alarm
111 Smoke Alarm
121 Duress
122 Silent Panic
123 Audible Panic
124 Duress Access Grant
125 Duress Egress Grant
131 Perimeter Burglary
132 Interior Burglary
133 24-Hour Burglary
134 Entry/Exit Burglary
135 Day/Night Burglary
140 ACS Zone Alarm
150 24-Hour Auxiliary
162 CO Alarm
301 AC Loss
302 Low System Battery
305 System Reset
306 Program Tamper
308 System Shutdown
309 Battery Test Fail
313 System Engineer Reset
320 ACS Relay Supervision
321 Bell 1 Trouble
332 Poll Loop Short-Trouble
333 Expansion Module Failure
338 ACS Module Low Battery
339 ACS Module Reset
342 ACS Module AC Loss
343 ACS Module Self-Test Fail
344 RF Receiver Jam Detect
354 Dialer Queue Overflow
373 Fire Loop Trouble
374 Exit Error by Zone
378 Cross Zone Trouble
380 Trouble (global)
381 Loss of Supervision (RF)
382 Loss of RPM Supervision
383 RPM Sensor Tamper
384 RF Transmitter Low Battery
385 Smoke Detector HI
386 Smoke Detector LO
389 Detector Self-Test Failed
401 O/C by User
403 Power-Up Armed/Auto-Arm
406 Cancel by User
407 Remote Arm/Disarm (Download)
408 Quick Arm
409 Keyswitch O/C
411 Callback Requested
421 Access Denied
422 Access Granted
423 Door Force Open

Section 15 : Contact ID Codes

Code Definition
424 Egress Denied
425 Egress Granted
426 Door Prop Open
427 Access Point DSM Trouble
428 Access Point RTE Trouble
429 ACS Program Entry
430 ACS Program Exit
431 ACS Threat Change
432 Access Point Relay/Trigger Fail
433 Access Point RTE Shunt
434 Access Point DSM Shunt/Unshunt
441 Armed STAY
451 Early Open/Close
452 Late Open/Close
453 Fail to Open
454 Fail to Close
455 Auto-Arm Fail
459 Recent Close
501 ACS Reader Disable
520 ACS Relay Disable
570 Bypass
576 ACS Zone Shunt
577 ACS Point Bypass
579 Vent Zone Bypass
601 Panel Test via Compass Software
602 Communicator Test
606 Listen-In to Follow
607 Burglary Walk-Test
621 Event Log Reset
625 Time/Date Reset
631 Exception Schedule Change
632 Access Schedule Change
NOTE: If 2∗03 ULC S304 feature is enabled and there
is a phone line (or radio) failure and the panel
has exhausted its maximum attempts to send
reporting events to the central station, the panel
will hold the messages in a buffer and resend
upon restoral of the communication path. In
addition, old messages that are sent will
indicate that they are not current messages so
that the central station does not dispatch on
them.
In order to accomplish this, an event qualifier of
"6" will be sent in place of the "1" or "3"
character in the message. The "6" indicates that
the message is old. Events will be sent in
chronological order and will be time-stamped in
the system's event log
15-1
.