Downloading Using an AlarmNet Communicator
The control can be downloaded without using an approved AlarmNet communicator. For a list of compatible
communicators visit MyWebTech. This can be accomplished using the ECP bus as explained in Section 3 Installing the
Control.
Direct Connect Downloading
The control can be uploaded/downloaded on site via a direct connection. Below illustrates the proper wiring configuration
for direct connect downloading.
NOTE: The direct-wire downloading connection is to be temporary, and is not part of the permanent installation.
Direct-wire downloading is meant as a tool for the installer during the installation process.
Figure 37: Direct Download TB4 Connections
To connect follow the instructions below:
1.
Configure Compass for direct connecting (refer to Compass Installation and Setup Guide for more
information.)
2.
On an alpha keypad (non-touchscreen, such as a 6280 or Tuxedo Touch Wi-Fi) press Installer Code + # + 5.
3.
Press connect on the Compass software.
NOTE: For troubleshooting direct connecting issues, refer to https://mywebtech.honeywell.com/.
SECTION 6: SOFTWARE DOWNLOADING
Figure 38: Direct Download VT-SERCBL
6-1
Connections