Konica Minolta bizhub C754 User Manual page 380

15
Settings
[Destination]
[Line Setting]
[Communication Setting]
[Limiting Access to Desti-
nations]
15-10
Description
Enter the destination fax number (using up to 38 digits, including symbols
#, *, _, T, P, and E).
• If your environment is Private Branch Exchange (PBX), entering "E-"
first inserts the registered outside line number automatically.
• If your environment is Private Branch Exchange (PBX), entering "P" fol-
lowing the outside line number ensures the dialing.
• If you wish to send out a push signal over the dial line, enter "T".
• Enter "-" to separate a dial number. It does not affect the dialing of the
number.
If two lines are used, select the line used to send a fax. If [No Selection] is
selected, either line, whichever is not busy, is used for transmission.
As necessary, click [Display] and specify how to send a fax to a destination
you wish to register. You may change the settings you made here before
sending a fax.
• [V34 Off]: Generally, faxes are sent in the Super G3 mode. If it is not
possible to send faxes in the Super G3 mode, select this option.
• [ECM Off]: Generally, faxes are sent while checking that the fax data is
free of errors by using ECM (Error Correction Mode). To reduce the time
required to send a fax, select this option.
• [International Communication]: Select this option to send a fax to areas
where communication conditions are poor. Faxes are sent at a lower
speed.
• [Check Destination]: Select this option to use Check Dest. & Send. The
fax number specified for fax is checked against the remote fax number
(CSI) and the fax is sent only when they match.
Limit access to this destination, if necessary.
For details, refer to page 12-46.
Registering address books
bizhub C754/C654
15.1