13.6
Using IPsec communication
7
In [Enable IPsec], configure the following settings.
Settings
[IPsec]
[Dead Peer Detection]
[Cookies]
[ICMP Pass]
[ICMPv6 Pass]
[Default action]
bizhub C754/C654
Description
Select [ON] to use the IPsec.
If no response can be confirmed from the peer in a certain period, the SA
with the peer is deleted.
Select a time that elapses before sending survival confirmation information
to the peer how has not responded.
Select whether to enable the defense using Cookies against denial-of-
service attacks.
Select whether to apply IPsec to the Internet Control Message Protocol
(ICMP).
Select [Enable] to allow the ICMP packets to pass without applying IPsec
to the ICMP.
Select whether to apply IPsec to the Internet Control Message Protocol for
IPv6 (ICMPv6).
Select [Enable] to allow the ICMPv6 packets to pass without applying
IPsec to the ICMPv6.
Select an action to be taken if no settings meet the [IPsec Policy] while
IPsec communication is enabled.
Select [Deny] to discard IP packets that do not meet the [IPsec Policy] set-
tings.
13
13-21