Konica Minolta bizhub C754 User Manual page 312

13
Settings
[EAP-TTLS]
[Server ID]
[Client Certificates]
[Encryption Strength]
[Certificate Verifica-
tion Level Settings]
[Network Stop Time]
Tips
- In the administrator mode, select [Network] - [IEEE802.1X Authentication Setting] - [IEEE802.1X Au-
thentication Trial] to confirm the current authentication status. The authentication process can be acti-
vated for the authentication server.
13-24
Description
Configure the EAP-TTLS settings if [EAP-Type] is set to [EAP-TTLS] or [De-
pend on Server].
• [anonymous]: Enter the anonymous name used for EAP-TTLS authen-
tication (using up to 128 characters).
• [Inner Authentication Protocol]: Select an internal authentication proto-
col for EAP-TTLS.
To verify CN of the certificate, enter the server ID (using up to 64 charac-
ters).
Select whether to encrypt the authentication information using a certificate
for this machine, if necessary.
This setting can be configured if the following conditions are satisfied:
• The certificate is registered on this machine
• [EAP-TLS], [EAP-TTLS], [PEAP], or [Depend on Server] is selected from
[EAP-Type].
If [EAP-TLS], [EAP-TTLS], [PEAP], or [Depend on Server] is selected from
[EAP-Type], select an encryption strength for encryption by TLS, if neces-
sary.
• [Low]: Keys of any length are used for communication.
• [Mid]: Keys that are more than 56 bits in length are used for communi-
cation.
• [High]: Keys that are more than 128 bits in length are used for commu-
nication.
To verify the certificate, select items to be verified.
If you select [Confirm] at each item, the certificate is verified for each item.
• [Validity Period]: Confirm whether the certificate is within the validity
period.
[Confirm] is specified by default.
• [CN]: Confirm whether CN (Common Name) of the certificate matches
the server address.
[Do Not Confirm] is specified by default.
• [Chain]: Confirm whether there is a problem in the certificate chain (cer-
tificate path). The chain is validated by referencing the external certifi-
cates managed on this machine.
[Do Not Confirm] is specified by default.
Specify the delay time between the start of an authentication process and
the end of network communication, if necessary.
If an authentication process does not succeed within the specified time, all
network communication will stop.
To specify the delay time, select the [Network Stop Time] check box, and
enter the delay (sec.) in [Stop Time].
To restart the authentication process after network communication
stopped, reboot this machine.
Using the IEEE802.1X authentication 13.7
bizhub C754/C654