Registering User's Certificates Automatically On This Machine - Konica Minolta bizhub C754 User Manual
Hide thumbs
Also See for bizhub C754:
- User manual (427 pages) ,
- Quick start manual (130 pages) ,
- Shortcut manual (33 pages)
Table of Contents
Advertisement
13
13.4
Registering user's certificates automatically on this machine
Register a user's certificate used for encrypting E-mail message with S/MIME.
The following two methods are available for registering a user's certificate:
-
Registering a user's certificate as destination registration information when the E-mail address is reg-
istered on this machine.
-
Sending an E-mail attached with a digital signature (user's certificate) to this machine to register the
certificate automatically in this machine using S/MIME function.
The following describes the method to send an E-mail attached with digital signature (user's certificate) to
this machine for automatic registration.
0
Before registering the certificate, you must register on this machine the E-mail address of the user
whose certificate you wish to register.
0
This machine must be able to receive E-mail messages.
1
In the administrator mode, select [Network] - [E-mail Setting] - [S/MIME], then configure the following
settings.
Settings
[S/MIME Comm. Setting]
[Automatically Obtain Cer-
tificates]
[Print S/MIME information]
[Certificate Verification
Level Settings]
[Validity Period]
[Key Usage]
[Chain]
13-14
Registering user's certificates automatically on this machine
Description
Select [ON] to use the S/MIME.
To select [ON], the E-mail address of the certificate of this machine must
match the E-mail address of the administrator.
[OFF] is specified by default.
To register digital signature (user's certificate), select [ON].
[OFF] is specified by default.
Select whether to print the S/MIME information, if necessary.
[OFF] is specified by default.
To verify the certificate, select items to be verified.
If you select [Confirm] at each item, the certificate is verified for each item.
Confirm whether the certificate is still valid.
[Confirm] is specified by default.
Confirm whether the certificate is used according to the intended purpose
approved by the certificate issuer.
[Do Not Confirm] is specified by default.
Confirm whether there is a problem in the certificate chain (certificate path).
The chain is validated by referencing the external certificates managed on
this machine.
[Do Not Confirm] is specified by default.
13.4
bizhub C754/C654
Advertisement
Table of Contents
