Umpcfg - Broadcom NetXtreme User Manual

Broadcom NetXtreme Ethernet Adapter • Diagnostic User's Guide
-o
-c
-i
-a
-e
-d
10.226

umpcfg

Command: umpcfg
Description: Configure UMP in NVRAM
Syntax: umpcfg
1
UMP Settings
Description:
0
1
2
3
4
5
6
7
Save and Exit
2
Description:
non-volatile memory and exists.
3 Exit without Saving
Description:
Exits without saving any changes to the UMP Configuration Table.
Running UMP Echo Test with test firmware
Debug display of SRAM address 0xC00
Debug display of CPU code loading
Debug prompt after CPU code loading
Enable New UMP Echo Test in UMP Firmware
Disable New UMP Echo Test in UMP Firmware
Provides the sub menu with the options described below.
Return to previous menu.
Enable/Disable SetLink
Enable/Disable RDIStallTimer
Set RDIStallTimerValue
DisableHostHashTable
Enable/Disable HostEchoControl
Enable/Disable Exceed_375ma_rule
Link Speed
0 : Return to previous menu
1 : Speed 10/100 (default)
2 : Speed ALL
3 : Speed 10
4 : Speed 100
5 : Speed 1000
6 : Duplex
7 : Auto/Force Mode
8 : Pause Capability
Saves the modified UMP Configuration Table to the network adapter's
page 174
Broadcom Confidential and Proprietary