Table of Contents
Advertisement
Route
Version 1.5
Operator's Manual
again. Creating routes for the Route Bank uses the same methods as
the Active Route with a few exceptions: you can't use the GOTO'key,
and you can't use the Plotter screen. You can use other routes as a
subset to create a new route. Remember, you can always tie routes
together in the Active Route by inserting one after another. You will
find
a
Route Name softkey when you first enter the edit mode. The
Route Name selection allows you to identify each route by name,
number and symbol when you are viewing the Route Bank from the
main menu. To create a route:
I.
Select the RTE key until the RTE2 screen is displayed.
2. Move the cursor to the route number you want to create or edit.
3. Press the Ekey.
4. Use the entry methods described in the Creating a Multi- Waypoint
Active Route section, following the exceptions noted above.
_._-------
-- IJPTs / --- HM
Ifyou have a route in RTEl that is not stored in RTE2, you can copy
it into the Route Bank by selecting Insert then Insert Route, either
in the forward or reverse direction.
5. When you are finished selecting waypoints, press the Route Name
softkey.
You can enter any name, number or symbol you want this route to
be identified by.
45
Advertisement
Table of Contents
