Operation - General Setup And Control Settings - Leica MX420 Operator's Manual

Configuration Operator's Manual
Operation - General Setup and Control Settings
This screen controls a few basic operating settings:
Remember Display: When set to Yes (default), the receiver remem-
bers the Page Number or screen you viewed the last time you
used a particular function. For example, if you normally moni-
tor the NAV3 display and you decided to look at the PLOT]
screen, the next time you press the NAV function, the receiver
will automatically revert to the NA V3 screen immediately.
~~'i"1~2?r':'!~~~~:T'~i5'N'_1
Language ReMeMber display: Yes :
Light.ing Edit.
tiME-OUt.:
Hone:
Log Preceding zeroes: No
Log Pulses Beeper: __ On :
MX480 Ret.ain ext.ernal alarM: Off
i
Navigation Engineering display: No :
NMERoul 1 .
NMERoul 2
00·14$.41·1,.
Org~nft.zer
If you select No for Remember Display, the receiver will al-
ways display the first page of a function when you press the
function key.
Edit Timeout: You can set the timeout limit between None (de-
fault), or 1 to 10 minutes. If you enter the edit mode on any
screen and have a timeout period other than None, the re-
ceiver will automatically exit the edit mode ifno keys are touched
and the timeout period expires.
Preceding Zeroes: Places zeroes (Os) before directions less than
100° when Yes is selected. For example, 079°. Otherwise direc-
tions are shown without the leading zeros whenNo is selected
(default). For example, 79°.
Beeper: If you attempt to perform a key function that is not al-
lowed, you normally hear an Error Tone. This is performed
when the Beeper is set to On (default). If you don't want to
hear the error or any other keyboard beep, set the Beeper to
Off.
Retain External Alarm: Allows the CDU to hold the external alarm
while the alarm condition still exist. When Retain external
alarm is set to On, the external alarm will normalize only when
the cause of alarm is corrected.
Version 1.5
121