vvevooint
Operetor's Manual
9. Then press the Efunction key to end editing.
You can press the Ekey when you finish editing a waypoint. This
is treated the same as pressing the Done softkey. Pressing Done
allows you to continue editing and entering other waypoints.
IJPT:
IJPT:
1 N 33'42.5818
IJRECK~
IJRECK~
1.1118'16.1172
IJPT:
100
100 N 52'59.2170
T M30
E 4'56.9260
101 N
Re""""
Waypoint Lock/Unlock
Locking a waypoint forces the userto consciously unlock the waypoint
before it can be modified and prevents the waypoint from being over-
written when waypoints are being input over the data port. Note that
when a waypoint received on the data port has the same waypoint
number as a locked waypoint already stored in the CDU, the waypoint
data received on the data port is disregarded and lost. Waypoints are
locked by one of three methods:
1)
selecting Lock this WPT when in
the waypoint bank edit mode for a particular waypoint; 2) selecting
Lock this WPTwhen in the waypoint bank edit mode; or
3) incorporat-
ing a waypoint into a route stored inRTE2 and then locking the route.
Waypoints that are locked from the waypoint bank are indicated by a
closed padlock in the display. Waypoints that are party to a locked
route will display a message indicating that waypoint can not be modi-
fied.
To Lock
a
Waypoint
I. Select the WPT key until the WPTI screen is displayed.
2. Move the cursor to the desired waypoint.
3. Press the Ekey.
Version 1.5
53