Table of Contents
Advertisement
Configuration
Log Pulses - GPS SOG Log Pulse Output
Operator's Manual
This screen controls the output port (Pulse) of the speed over ground
log output from the MX420 CDU at a user-defined pulse rate per nau-
tical mile. This output is normally used to feed GPS SOG to an ARPA
radar. The default state is that the speed log is not active, and set to
200 pulses per nautical mile. Refer to the MX 420 Installation
&
Ser-
vice Manual for the hardware interface from one of the NMEA output
ports (NMEA I or 2 for the MX420/2 and NMEA I, 2 or 5 through 10
for the MX420/8 models)
[@'
C FG
f _
t=? j3' p"UL;'s'e:s .
IteM:
Pulse Loo EMulation:
Depth
EMulation enabled:
~ ;
DGPS
Output port:
NMERl out:
DR
Pulses per NM:.
200
i
GPS
Initial Pos
Language
Lighting
Lo"
(~;.!.i:m
&4-.
MX480
Change
'©CFGT
;a
IteM:
Depth
DGPS
DR
GPS
Inilia! Pos
Language
Lighting
LOQ
1i(.I·.:mY4--iI
MX480
-
.
-.'-
.........................................................
LOG PULSES.
Pulse Loo
Ef"lul.~lion:
:
EMI...dation enabled:
Yes ;
Output port:
NMER lout :
Pulses per NM:
" .. 5Cffi
j
Activate the output by selecting Yes to Emulation Enable, select the
appropriate hardware port, and set the pulse rate based on the device
that you are connecting to.
MX480 - MX480 PC Chart Interface Control
The MX420 CDU can be interfaced with the Leica MX480 a PC based
electronic charting software. When the MX480 mode is enabled, the
charting program assumes the following functions of the receiver:
• Active Route Creation
• Waypoint Library
• Tides
The COM I port of the PC must be connected to the RS-232 port of
NMEA 2 of the CDU (refer to the Installation
&
Service Manual).
Version 7.5
'i~)"CFifr
IteM:
DGPS
DR
GPS
Initial Pos
Language
Lighting
Log
L&!pPulses
lA
p-
_
.
MX4S0
........... No:
11X480 uses PORT 2
771
Advertisement
Table of Contents
