Insert Route - Leica MX420 Operator's Manual

Route
Insert Route
Operator's Manual
6. When the information is correct, press the Done softkey.
7. You can then choose to enter another waypoint using the same
method, select Escape to go back one level and use another method
to enter waypoints, or select Done to go back to the main menu.
8. Don't forget to press the Ekey to end your editing.
The following example assumes RTEl is empty. Follow the directions
in the Erasing an Existing Route section to start with an empty route
if you have waypoints in the RTEl screen.
To perform this function, you must also have defined a route in the
RTE2 screen. The RTE2 description follows later in theRoute section.
1.
Select the RTEkey until the RTEl screen is displayed.
2. Press the Ekey to enter the edit mode.
3. Select Insert from the display. Skip to the next step ifRTEI is empty.
4. Select Insert Route from the display.
Rctive Route:
OWPTs- .
-IJPTs/-HM
"Rout"-"T:"----
IJPTs7=:::::-H;;;-
FrOM:
To:
Version 7.5
5. Use the cursor key to scroll through the available defined routes,
which are created in the RTE 2 screen, in numerical order.
6. When you have found the route you want, press the Insert Fwdor
the Insert Reverse softkey. Insert Fwd enters the route from the top
of the defined list into the active route. Insert Reverse enters the
route from the bottom of the defined list into the active route so
that you can travel down the route in the reverse direction.
7. You can then choose to select another route using the same method
or select another method to enter waypoints,
8. Don't forget to press the Ekey to end your editing.
37