Table of Contents
Advertisement
Operator's Manual
Keypad & Display Description
capable of performing this function from a remote contact closure in-
put via Cable B (MOBlEvent) wire. Refer to the
Installation & Service
Manual
for interface instructions.
@GOTO
This function key allows you to quickly create a route from your present
position to one other waypoint. This single waypoint route can use an
existing waypoint from the Waypoint Bank, or you can quickly create
one by either defining" the appropriate coordinates or specifying a
range and bearing.
"
Be careful when you use this selection, as it will erase your current
active route when
it
creates the new one. Read through the
ROUTE
and
PLOT
sections of this manual to find other ways to use this key
within an active route.
@
LIGHT
This function key allows you to quickly switch between two predeter-
mined display lighting conditions. You can have two daytime settings,
two night time settings, or a daytime/night time setting. Select the CFG
function key and scroll down to the
Lighting
menu choice to make the
desired adjustments. Refer to the
Configuration
section ofthe manual
for a complete description of the
Lighting
menu options.
@
POWER ON/OFF
This function key turns the unit on and off. When depressed while the
unit is on, you will be prompted to select a
YES
or
NO
softkey to
confirm your action. This is known as a
software power off
lfthe operating program should hang up for any reason, you can also
perform a
hardware power
offby
continuing to depress the power
onl
off function key for about 5 seconds. When the GPS is turned off
using this technique, you can not reapply power for 10 seconds.
Note: An occasion may arise when you need to reset
the memory back to the factory default values.
Doing this will cause the
eDU
to lose all of your
defined settings, as well' as all 2,000 of your
weypoints and routes. Ifyou hold down the fifth
({/~il! /iiU:"':)
;:;._ilu,c;j'
..,'tij~1I
power is appiied tor
12
Version 1.5
Advertisement
Table of Contents
