Table of Contents
Advertisement
Configuration
Operator's Manual.
Here is a sample of the Brie/format with an active route or MOB
condition:
Leica
MX420/8
Navigator
11 Aug 1997
Datum:W84
118 21.0213
Version 1.5
====================================
21:24:00
VTe
POS Mode : DGPS
3D
POS: N
33 48.5124
W
eOG: 152T
SaG:
0.1 Kn
BRG: 239T Dist: 27.4 Nm XTE:0.14L Nm
RTE: RL
From WPT 1234
To WPT 1357
Sending: Causes the printer output to be turned On or Off(default).
Printer Interval (Sec): Allows you to control how often, in seconds,
the print out will be sent out of the printer port. The default value
is 60 seconds, and the valid range is from 1 to 9999 seconds.
Format: Allows you to choose either the Full or Brie/formats
described above.
Baud Rate: This allows to control the port interface baud rate to
match the printer or computer you are interfacing with. The
available baud rates are: 600, 1200,2400,4800,9600 (default), or
19,200.
Data Bits: This allows you to match the printer's requirement of 7 or
8 (default) bit serial data.
Stop Bits: This allows you to match the printer's requirement of 1
(default) or 2 stop bits.
Parity Check: This allows you to match the printer's requirement of
No (default), Even or Odd parity.
Handshake: This allows you to match the printer's requirement of
No (default), XONIXOFF or HW(Hardware; CTS, RTS - requires
pins 1,3, and 5 ofthe of the Multiport interface connector)
handshaking.
127
Advertisement
Table of Contents
