Table of Contents
Advertisement
Configuration
Operator's Manual
tion accuracy is becoming bad, duc to poor satellite geometry rcla-
tive to your position and/or the number of satellites currently un-
der track. You may want to sct thc alarm to
l'es
if position accuracy
is critical to you. Otherwise this alarm is normally set to No.
HDOP Alarm Limit:
Sets the HDOP value which will cause the alarm to sound. The
default value is 4. The valid range is from 1.0 to 9.9. The higher your
HOOP value, the more error you will have in your position fix. Refer
to the GPSl Current Satellite Status section of this manual for
more information about the HDOP value.
Alarm
if
No Update:
This setting causes an alarm when you stop calculating a position
fix for a few seconds when set to Yes (default). A setting of No
disables the alarm when position fix can not be obtained.
Printout
2 -
Printer Output Control
This menu item controls the printer output sometimes required for
commercial shipping. The interface is accomplished on NMEA Out 2
port. It can be configured for either RS-232 (pins 4 and 2 ofthe Multiport
connector) or RS-422 (pins 25 and 22 of the Multiport connector). The
printer output is simple ASCII text designed to operate on any serial
line printer, including narrow column printers.
The receiver has two print formats, namely: Full or Brief
Version 7.5
©CF61
Itel'l:
Operation
Organizer
Posilion
I@Mp;mN
Security
Serial I/O
TiMe
Wind
WPT&RTE In
PRINT OUTPUT
2
'
Printer
Conri9ur~lio~;
I
Sending
Off
725
Advertisement
Table of Contents
