Table of Contents
Advertisement
Configuration
Operator's Manual
intervals (typically every few seconds). The available choices are
Yes (default) or No.
AWA Offset: Allows you to input a constant angle correction value.
A WS Correction Factor: Allows you to input a wind speed correction
factor.
Input Sentence: Specifies the NMEA 0183 data sentence to read the
depth data from. The available choices areAny (default), MWV, or
VWR
sentence. It is better to specify the appropriate sentence,
because more than one method ofreporting wind may be available
on the port.
Wpt & Rte Input - Uploading Waypoints into the Receiver
This screen enables the input data port to recei ve waypoints and routes
from a chart plotter, PC, or other device to the receiver. You can receive
this data through any of the user NMEA 0183 input data ports. Load
the WPL sentences first, then the RTE sentences. Change Transducer
Connected from No (default) to Yes and select the appropriate port.
Refer to the Waypoints - Uploading Waypoints from Other Devices
section ofthis manual for more details orithe software interface. Refer
to the Installation & Service 'Manual for hardware interface.
Version 1.5
©CFGl
It.eM:
Operat.ion
Organizer
Posit.ion
Print.out. 2
Securit.y
Serial I/O
TiMe
Wind
1,IF'WF:TE
In
WPT&RTEINPUT
IdPT&RTE Input Configuration:
Ext.ernal "'PT
Input.:
Ho
IIncoNng
waypoint.s will
be
I
stored in local dat.\m.
131
Advertisement
Table of Contents
