Figure 65 Affixing a label
TO:
–
B03
48V2
Bind cable ties on both ends of a cable. After the bundling, the finished identification plate should be
on top of the cable in horizontal cabling, or on the right side of the cable in vertical cabling. Make
sure the label is facing out, as shown in
Figure
66.
Figure 66 Affixed labels
Affixing a generic label
The requirements for affixing a generic label are the same as affixing a label on a signal cable. For
more information, see
"Affixing a label to a signal
cable." For the example of affixed labels,
see
Figure
64.
100