Electromagnetic Compatibility (Emc; Guidance And Manufacturer's Declaration - Electromagnetic Emissions - GE Solar 8000M/i Service Manual

Appendix B – Electromagnetic compatibility: Electromagnetic compatibility (EMC)

Electromagnetic compatibility (EMC)

Guidance and manufacturer's declaration — electromagnetic
emissions
Emissions test
RF Emissions (radiated)
EN 55011
RF Emissions (conducted)
EN 55011
Harmonic Emissions
EN 61000-3-2
Voltage Fluctuations/
Flicker Emissions
EN 61000-3-3
B-2
Changes or modifications to this system not expressly approved by GE
can cause EMC issues with this or other equipment. This system is
designed and tested to comply with applicable regulation regarding EMC
and must be installed and put into service according to the EMC
information stated in this supplement.
CAUTION
Use of portable phones or other radio frequency (RF)
emitting equipment near the system may cause
unexpected or adverse operation.
CAUTION
The equipment or system should not be used adjacent to,
or stacked with, other equipment. If adjacent or stacked
use is necessary, the equipment or system should be
tested to verify normal operation in the configuration in
which it is being used.
The Solar 8000M/i is intended for use in the electromagnetic
environment specified below. It is the responsibility of the customer or
user to assure that the Solar 8000M/i is used in such an environment.
Compliance
Group 1 The equipment uses RF energy only for its internal function. Therefore, its RF
Class A emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
Group 1
Class A
CAUTION
Class A
The equipment is suitable for use in all establishments other than domestic and
those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Complies
Solar 8000M/i patient monitor
Electromagnetic environment – guidance
2026265-075C