GE Solar 8000M/i Service Manual page 46

Remote control or keypad
PRN-50 digital writer and respiratory mechanics module
3-8
Installation: Front panel connectors and indicators
The following devices connect to M-Port hosts using AutoPort to M-Port
adapter PN 2001973-001.
PRN-50 digital writer with AutoPort
Respiratory mechanics module with AutoPort
NOTE
AutoPort to M-Port adapter PN 2001973-001 is required for
connecting AutoPort devices to M-Ports. Plug the adapter end
labeled AutoPort into the AutoPort device.
The remote control or keypad is DIDCA programmed for specific care
areas (adult, neonatal, or operating room). A keypad holster mount is
available for mounting under the display.
NOTE
The Solar 8000M/i requires an interface (remote control or keypad)
with all display types.
NOTE
The error message WARNING: REMOTE MISMATCHED WITH
MONITORING MODE displays if a mismatched keypad/remote
control is connected to the Solar 8000M/i patient monitor.
The figure below shows the PRN-50-M digital writer connected to one of
the M-Ports. The RM-M respiratory mechanics module has similar
connections.
Solar 8000M/i patient monitor
AutoPort or M-Port connector.
Note: If this is a PRN 50 or RM module with
AutoPort, then adapter PN 2001973-001 is
required.
016A
2026265-075C