RS4 50 MY2011
Electrical system
TABLE D - Wire connection on transducer
(CDI)
8. Transducer (CDI)
9. The yellow cable that stays free on the flywheel
cable harness, is connected to the Yellow Red ca-
ble that is provided by the Main Cable harness.
(see CENTRAL SECTION, TABLE E5, SPECIAL
21)
10. On the "STOP" input connect the White-Red
cable in the branch of the Main Cable harness.
11. ATTENTION Connect the cables from the
flywheel to the transducer according to the
written colours on the transducer (as shown in
the picture).
12. Flywheel cable
TABLE E - Installing main cable harness
13. Relay 5 contacts for vehicle shut off
14. Main fuse
15. CAUTION: If the cables are not correctly
positioned or if wrong relay is used, can not be
shut off the motorcycle.
16. Clamps
ELE SYS - 69