Table of Contents
Advertisement
RS4 50 MY2011
- Warm up at about 60°C (140°F) the seats of the
crankshaft, main shaft, secondary shaft on the left
hand side
- Separate the two crankcase halves with the spe-
cific tool
CAUTION
NEVER USE A LEVER OR A SCREWDRIVER TO SEPA-
RATE THE CRANKCASE HALVES. REPLACE THE CRANK-
CASE HALVES IF THE COUPLING SURFACES GET DAM-
AGED.
Specific tooling
AP8106698 Crankcase separator
Removing the crankshaft
- Open the crankcase halves and remove the gear-
box shafts
- Warm the crankshaft seat on the clutch side at
about 60°C (140°F) and take out the crankshaft
See also
Disassembling the gearbox
Engine
ENG - 125
Advertisement
Table of Contents
