RS4 50 MY2011
- Clean and lubricate the main bearings
- Replace them if there are signs of abnormal
wear, deformations or jams.
- Thoroughly clean and degrease all the compo-
nents of the gear housing, the selector and the
shaft
- Reassemble the secondary shaft making sure all
components are fitted correctly
- Refit the gear unit in the crankcase (the main and
the secondary shafts must be mounted at the
same time)
- First check the overall volume of the secondary
shaft including shimmings
Characteristic
Secondary shaft overall height
Max. 87.7 mm (3.4527 in) Min. 87.35 mm (3.4390
in)
Gear selector
Removing the gear selector
- Take out the clutch assembly
Engine
ENG - 103