Electrical system
•
MIX oil reserve sensor connector (check if connected and if there are pins slide off) - CEN-
TRAL SECTION, TABLE C.
•
Check proper connection of transducer cables (CDI) - CENTRAL SECTION, TABLE D.
•
Check MIX oil warning light ignition - FRONT SECTION, TABLE G.
The connectors in the list are circled in "green" in the different pictures.The listed connectors
are considered more critical than the others because their disconnection could cause the ve-
hicle to stop or malfunction. Obviously, the correct connection of the other connectors is also
important and essential for proper vehicle operation.
It is also important and essential that the instructions regarding the routing and fixing of the cable har-
ness in the various areas are followed meticulously in order to guarantee functionality and reliability.
The installation is shown on the three ideal divi-
sions of the vehicle:
1. Front section
2. Central section
3. Rear section
Front side
TABLE A - FRONT LIGHT PRE-FITTING
1. High beam light
2. Cable guide
3. Grey sheathing that indicates the cable for the
left HIGHBEAM headlight
4. Clamps
5. Low beam light
6. Cable harness headlight
7. Daylight running light connections (3+3W)
8. Daylight running light (3W)
ELE SYS - 60
RS4 50 MY2011