Qfx5200 Management Panel; Figure 3: Qfx5200 Switch, Fru End; Table 8: Network Port Link/Activity Leds On Qsfp+ Ports On A Qfx5200 - Juniper QFX5200 Hardware Manual

Table 8: Network Port Link/Activity LEDs on QSFP+ Ports on a QFX5200

Color State
Unlit Off
Green On steadily
Blinking
Amber Blinking
Related
Documentation

QFX5200 Management Panel

Copyright © 2017, Juniper Networks, Inc.
an optical splitter cable or a copper DACBO cable.
interpret the QSFP+ LEDs.
Description
The port is administratively disabled, there is no power, the link is down, or there is
a fault.
NOTE: When configured for 10-Gigabit Ethernet, the LED remains unlit only if all
four of the 10-Gigabit Ethernet SFP+ breakout links are down.
A link is established, but there is no link activity.
NOTE: When configured for 10-Gigabit Ethernet, the LED is lit green when at least
one of the four 10-Gigabit Ethernet SFP+ breakout links is established.
A link is established, and there is link activity.
NOTE: When configured for 10-Gigabit Ethernet, the LED is lit green when at least
one of the four 10-Gigabit Ethernet SFP+ breakout links is established.
All four LEDs blink to indicate the beacon function was enabled on the port.
QFX5200 Management Panel on page 11
Installing a Transceiver in a QFX Series Device
Connecting a Fiber-Optic Cable to a QFX Series Device
The management panel of the QFX5200 switch is found on the Field Replaceable Unit
(FRU) end of the switch as shown in
FRUs and management panel detail.

Figure 3: QFX5200 Switch, FRU End

1— Management panel
2—Fan modules
Chapter 2: Chassis Components and Descriptions
Table 8 on page 11
Figure 3 on page 11. See Figure 4 on page 12
3— Power supply units
describes how to
for
11