QFX5200 Switch Hardware Guide
Related
Documentation
Removing a QFX5200 from a Rack or Cabinet
102
Halting system...
System halted.
CAUTION:
The final output of any version of the
command is the "The operating system has halted." Wait at least 60
seconds after first seeing this message before following the instructions
in Step
4
and Step
Attach the grounding strap to your bare wrist and to a site ESD point.
3.
Disconnect power to the switch by performing one of the following tasks:
4.
AC power supply—If the AC power source outlet has a power switch, set it to the
OFF (O) position. If the AC power source outlet does not have a power switch, gently
pull out the male end of the power cord connected to the power source outlet.
DC power supply—Switch the circuit breaker on the panel board that services the
DC circuit to the OFF position.
Remove the power source cable from the power supply faceplate:
5.
AC power supply—Remove the power cord from the power supply faceplate by
detaching the power cord retainer and gently pulling out the female end of the
power cord connected to the power supply faceplate.
DC power supply—Remove the screws securing the ring lugs attached to the power
source cables to the power supply using the screwdriver, and remove the power
source cables from the power supply. Replace the screws on the terminals and
tighten them.
Uncable the switch before removing it from the rack or cabinet.
6.
Connecting AC Power to a QFX5200 on page 65
Connecting DC Power to a QFX5200 on page 68
If you need to relocate an installed QFX5200, use the procedure described in this topic.
(The remainder of this topic uses "rack" to mean "rack or cabinet." )
NOTE:
When you remove multiple switches from a rack, remove the switch
in the top of the rack first and proceed to remove the rest of the switches
from top to bottom.
Before removing a QFX5200 from a rack:
5
to power off the switch.
Copyright © 2017, Juniper Networks, Inc.
request system halt
Need help?
Do you have a question about the QFX5200 and is the answer not in the manual?