Qfx5200 Field-Replaceable Units; Chassis Components And Descriptions; Table 5: Frus In A Qfx5200 Switch - Juniper QFX5200 Hardware Manual

Related
Documentation

QFX5200 Field-Replaceable Units

Table 5: FRUs in a QFX5200 Switch

FRU
Power supplies
Fan modules
Optical transceivers
Copyright © 2017, Juniper Networks, Inc.
To channelize the ports, manually configure the port speed using the
slot-number port port-number channel-speed speed
set to 10G, 25G, 50G, or 100G. The ports do not support autochannelization.
QFX5200 Field-Replaceable Units on page 9
Channelizing Interfaces on QFX5200 Switches
QFX5200 Access Port and Uplink Port LEDs on page 10
Installing and Removing QFX5200 Hardware Components on page 99
Field-replaceable units (FRUs) are components that you can replace at your site. The
QFX5200 device FRUs are hot-insertable and hot-removable: you can remove and replace
one of them without powering off the switch or disrupting the switching function.
CAUTION: Replace a failed power supply with a blank panel or new power
supply within one minute of removal to prevent chassis overheating. The
switch continues to operate with only one power supply running. Replace a
failed fan module with a new fan module within one minute of removal to
prevent chassis overheating. Do not operate the switch with missing FRUs
for longer than one minute.
Table 5 on page 9 lists the FRUs for the QFX5200 device and actions to take before
removing them.
Required Action
None.
None.
None. We recommend that you disable the interface using the set interfaces
interface-name disable command before you remove the transceiver. See
Disconnecting a Fiber-Optic Cable from a QFX Series Device.
NOTE: If you have a Juniper Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
Chapter 2: Chassis Components and Descriptions
set chassis fpc
command, where the speed can be
. Failure
9