Juniper QFX5200 Hardware Manual page 141

Table 32: Chassis Alarm Messages (continued)
Component Alarm Type
Temperature Major (red)
sensors
Minor (yellow)
Routing Engine Minor (yellow)
Major (red)
Minor (yellow)
Copyright © 2017, Juniper Networks, Inc.
CLI Message
sensor-location Temp Sensor Fail
sensor-location Temp Sensor Too Hot
sensor-location Temp Sensor Too Warm
RE RE number /var partition usage is high
RE RE number /var partition is full
Rescue configuration is not set
Feature usage requires a license
or
License for feature expired
Chapter 19: Alarm Messages
Recommended Action
Check the system log for the following
error message and report the message
to customer support:
Temp sensor sensor-number failed
sensor-number ranges from 1 through 10.
Check environmental conditions and
alarms on other devices. Ensure that
environmental factors (such as hot air
blowing around the equipment) do not
affect the temperature sensor. If the
condition persists, the device might shut
down.
Check environmental conditions and
alarms on other devices. Ensure that
environmental factors (such as hot air
blowing around the equipment) do not
affect the temperature sensor.
Clean up the system file storage space
on the switch. For more information, see
Cleaning Up the System File Storage
Space.
Clean up the system file storage space
on the switch. For more information, see
Cleaning Up the System File Storage
Space.
Use the request system configuration
rescue save command to set the rescue
configuration. For more information, see
Setting or Deleting the Rescue
Configuration.
Install the required license for the feature
specified in the alarm. For more
information, see Software Features That
Require Licenses on the QFX Series.
, where
123