Removing A Power Supply From A Qfx5200; Figure 32: Installing A Power Supply In A Qfx5200 - Juniper QFX5200 Hardware Manual

QFX5200 Switch Hardware Guide
Related
Documentation

Removing a Power Supply from a QFX5200

86

Figure 32: Installing a Power Supply in a QFX5200

NOTE: Each power supply must be connected to a dedicated power source
outlet.
NOTE: If you have a Juniper Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
QFX5200 AC Power Supply on page 23
QFX5200 Field-Replaceable Units on page 9
AC Power Cord Specifications for a QFX Series Device on page 39
Connecting AC Power to a QFX5200 on page 65
Connecting DC Power to a QFX5200 on page 68
Removing a Power Supply from a QFX5200 on page 86
The QFX5200 is shipped from the factory with two power supplies. Each power supply
is a hot-removable and hot-insertable field-replaceable unit (FRU) when the second
power supply is installed and running. You can install replacement power supplies in the
two slots next to the fan modules without powering off the switch or disrupting the
switching function.
Before you remove a power supply from a QFX5200, ensure that you have taken the
necessary precautions to prevent electrostatic discharge (ESD) damage (see
of Electrostatic Discharge Damage" on page
Ensure that you have the following parts and tools available to remove a power supply
from a QFX5200:
ESD grounding strap
156).
Copyright © 2017, Juniper Networks, Inc.
. Failure
"Prevention