Siemens SINUMERIK 808D Programming And Operating Manual page 4

Preface
Standard scope
This documentation only describes the functionality of the standard version. Additions or
revisions made by the machine manufacturer are documented by the machine manufacturer.
Other functions not described in this documentation might be executable in the control.
However, no claim can be made regarding the availability of these functions when the
equipment is first supplied or in the event of servicing.
For the sake of simplicity, this documentation does not contain all detailed information about
all types of the product and cannot cover every conceivable case of installation, operation, or
maintenance.
Technical support
Hotline:
Service and Support
EC Declaration of Conformity
The EC Declaration of Conformity for the EMC Directive can be found on the Internet at
http://support.automation.siemens.com
Here, enter the number 15257461 as the search term or contact your local Siemens office.
Licensing provisions
The SINUMERIK 808D software is protected by national and international copyright laws and
agreements. Unauthorized reproduction and distribution of this software or parts thereof is
liable to prosecution. It will be prosecuted both according to criminal and civil law and may
result in severe punishment or demands for compensation.
In the SINUMERIK 808D software, open source software is used. The licensing provisions
for this software are included on the Toolbox DVD and are to be observed accordingly.
4
+86 400-810-4288
China:

www.siemens.com.cn/808D
Worldwide:

http://support.automation.siemens.com
Programming and Operating Manual, 12/2012, 6FC5398-3DP10-0BA0
Manual Machine Plus (Turning)