Groove Cycle - Multiple - Siemens SINUMERIK 808D Programming And Operating Manual

6. Finishing is started immediately after the roughing operation. The entire contour is
7. Finally, the original position of the axes before the start of machining is approached
See also
Principle operating sequence (Page 38)
General parameters (Page 41)
3.4.5.2

Groove cycle - multiple

Functionality
Note
The "Multiple groove" function supplements the "Single groove" option. This function can be
used only if all the parameters for the "Groove cycle - single" function have been assigned!
As soon as you position the cursor in any of the input fields in the multiple grooves area of
the screen, the display changes from single groove to multiple grooves:
Figure 3-27
Manual Machine Plus (Turning)
Programming and Operating Manual, 12/2012, 6FC5398-3DP10-0BA0
traversed from both sides to the center of the base of the groove at the feedrate specified
in the "Technology Data" screen before the start of the cycle.
diagonally.
Groove cycle - multiple
3.4 Manual machining using cycles (functions)
Manual machining
51