Figure 4-4
This function inserts a positioning block at the current machine axis position in the selected
machining step.
This function deletes the currently selected machining step.
To interrupt the function "Machining step program" press "Cancel".
This softkey returns you to the main screen for "Manual Machine Plus".
If you have changed any values, a prompt window informs you accordingly.
Press "OK" to save the values
Press "Cancel" to discard the settings.
The machining step program is saved.
This softkey returns you to the main screen for "Manual Machine Plus".
Inserting a tool change into the program.
Change into the dialog box for tool change (Page 91).
Inserting a traversing block in the program.
Inserting a roughing cycle in the program.
Change into the dialog box for roughing cycles (Page 65).
Inserting a drilling cycle in the program.
Change into the dialog box (Page 43) for the drilling cycles (Page 46).
Manual Machine Plus (Turning)
Programming and Operating Manual, 12/2012, 6FC5398-3DP10-0BA0
Machining step program
Machining the machining step program manually
89