Siemens SINUMERIK 808D Programming And Operating Manual page 40

Manual machining
3.4 Manual machining using cycles (functions)
3. The function was parameterized (e.g. thread tapping).
4. Start machining using the <CYCLE START> key.
5. If machining was terminated (e.g. "Machining completed"), then the execution screen can
Note
At Point 2, a detailed parameter description of each function can be found in the relevant
sections.
40
Activate the function using the "OK" softkey.
The following execute screen appears:
Figure 3-18 Example of executing a machining operation
The current machining status is displayed in the center of the execute screen. This status
could be one of the following:
– Machining not started
– Machining active
– Machining aborted
– Machining interrupted
– Machining finished
In the example, the text "Machining not started" is displayed.
The machining operation on the workpiece is executed.
Press the <CYCLE STOP> key if you want to interrupt the machining operation. The
selected direction of the spindle rotation continues to be activated.
By pressing the <CYCLE STOP> key, the "JOG" operating mode is automatically
changed, i.e. you can traverse the axes manually. By continuing the execution with
<CYCLE START>, the interruption point is approached again and execution of the
program is continued.
be exited using the "Cancel" softkey.
Programming and Operating Manual, 12/2012, 6FC5398-3DP10-0BA0
Manual Machine Plus (Turning)