Siemens SINUMERIK 808D Programming And Operating Manual page 85

Note
Only contours listed in the cycle overview can be machined. External contours cannot be
machined.
Figure 3-62
First, define the contour starting point.
References
The function "Machined contour" is described in detail in the chapter "Part programming;
Free contour programming, ... Define a start point" in the SINUMERIK 808D Turning
Programming and Operating Manual.
Rather than the auxiliary chart, the function displays the entered contour section.
Figure 3-63
Manual Machine Plus (Turning)
Programming and Operating Manual, 12/2012, 6FC5398-3DP10-0BA0
Machining window for free contours
Graphic view of a contour section
3.4 Manual machining using cycles (functions)
Manual machining
85