Table of Contents
Advertisement
Figure 26 Snap in the Floppy Drive Cable to JN8
3.5.4 Installing a Flash Memory Card
1.
Same procedures as described above (3.5.3 Item 1-4).
2.
Mount the Floppy Drive brackets to both side of the flash memory card
3.
Find the internal USB connector JN23, insert one end of the Flash Memory
Card cable provided, the other end of this cable shall installed to the Flash
Memory Card itself.
4.
Replace the two Phillips screws in the Hard Drive frame.
5.
Install the Phillips screw in the Floppy Drive brackets to mount the brackets
to the base unit.
3.5.5 Installing a PCI Expansion Card
1.
Remove the square metal cover from the outside rear of the computer located
between the IEEE-1394 and VGA ports. (One screw on the left of the
cover).
2.
Slide out the cover and the attached blanking plate. Remove the blanking
plate from the cover and set aside.
3.
Install the PCI slot riser card to the Motherboard edge connector by lining up
the edges and sliding it on. Look first to make sure you have the card lined
up correctly as it only fits one way.
H a r d w a r e I n s t a l l a t i o n
Cybernet Elite-4i User Guide
25
Advertisement
Table of Contents
