Cybernet Elite-4i User Guide
Install the 184-pin DDR modules in any combination as follows:
BANK 0 (XDIMM1)
BANK 1 (XDIMM2)
Total System Memory 128MB - 2.0 GB
3.3
CPU and CPU Heat Sink Installation
3.3.1 CPU Installation Procedure
1.
On the motherboard, identify the mPGA478B CPU Socket.
2.
Push the CPU socket lever slightly to the side and then raise it as far as it can
go.
3.
Identify the pin-1 corner of the mPGA478B socket. The pin-1 corner is on
the same side as the locking lever, as shown in the picture above.
4.
Identify the pin-1 corner of the processor (the pin-1 corner on the processor
has a beveled edge).
5.
Align the pin-1 corners and drop the processor into the mPGA478B socket.
The processor should drop into place without any force. If it doesn't seat
properly, check that you have the pin-1 corner in the correct position.
20
128/256/512/1024MB
128/256/512/1024MB
Figure 20 CPU Installation
H a r d w a r e I n s t a l l a t i o n