Installing A Optical Device; Figure 24 Installing The Hard Disk Drive Into The Base Unit - Cybernet Elite-4i User Manual

6. Replace the two screws at the front of the hard disk drive frame with a
Phillips screwdriver

Figure 24 Installing the Hard Disk Drive into the Base Unit

3.5.2 Installing a Optical Device

The multimedia device can be a slim type CD-ROM, CD-RW/DVD combo or
DVD-R/W. Connect the 50-wire ribbon cable from the optical drive to the JN16
connector.
1. First, remove the Keytop as instructed in Section 3.1.2.
2. Then, remove the blanking plate from the left side of the Keytop by pushing
in the center to pop it out of the notches on the side.
3. Lining up the CD-ROM door flush with the opening in the left side of the
Keytop, install the CD-ROM with the four Phillips screws provided.
4. Attach the 50-wire ribbon cable to the JN16 Connector on the left front of the
Motherboard.
5. The Plug and Play BIOS will auto detect the device without any software
configuration.
H a r d w a r e I n s t a l l a t i o n
.
Cybernet Elite-4i User Guide
23