Table of Contents
Advertisement
Cybernet Elite-4i User Guide
•
Change the First Boot Device to be the CDROM. Press F10 to Save and Exit.
8.5. Cannot get attached POS device to work.
•
The POS port on the back of the Elite-4i has a special bi-directional PS/2 port
pin-out and, therefore, MUST be used in conjunction with OUR POS Y-Cable.
No PS/2 POS devices will operate if simply connected directly into the POS
port.
•
In addition to utilizing our POS Y-Cable, the POS port must be Enabled using
two jumpers on the motherboard at location JP2. These must be set to position
3-5 and 4-6 to Enable the POS port.
•
Open the computer as instructed in section 3.1.2 of this guide.
•
Move the jumpers at JP2 as directed, in section 2.3.1 of this guide.
•
Link your POS device(s) to the Y-cable in a daisy-chained loop using both ends
of OUR Y-cable. This is necessary in order to have the keyboard matrix
operate in conjunction with any POS device(s).
8.6 Cannot get External Keyboard to work.
•
In order to use a PS/2 keyboard plugged directly into the POS port, the same
procedure (above in item #5) must be followed to Enable the POS port. This
will, of course, disable the built-in keyboard matrix of the Elite-4i.
•
Open the computer as instructed in section 3.1.2 of this guide.
•
Move the two jumpers at JP2 as directed in section 2.5.3 of this manual.
8.7 Cannot get Video-Out port to work.
•
The Video-Out port on the back of the Elite-4i is only enabled and operational if
the DVI Video feature option is ordered at the time of purchase. To determine
whether or not this feature was ordered, check the line items on your Sales
Order or Packing List for 'DVI Video Motherboard'.
66
T r o u b l e S h o o t i n g G u i d e s
Advertisement
Table of Contents
