Removing The Keytop Matrix; Figure 29 Removing The Keytop Matrix - Cybernet Elite-4i User Manual

1. Remove the keytop as instructed in section 3.1.2.
2. Remove the blanking plate by removing the two screws on either side of the
blanking plate (located between the case fan and the expansion slot).
3. Install fax/modem cable to header JN14 on the motherboard making sure to
line up the header and connector correctly. (The fax/modem cable only
installs one way).
4. Install the other end of the fax/modem cable to the fax/modem card.
5. Replace the two Phillips screws on either side of the fax/modem card from
the outside of the case.
3.6

Removing the Keytop Matrix

1. Remove the keytop as instructed in section 3.1.2.
2. Remove keyboard controller board and unfasten flex cable.
3. Remove optical drive if present.
4. Remove six Phillips screws to release keytop matrix.
H a r d w a r e I n s t a l l a t i o n

Figure 29 Removing the Keytop Matrix

Cybernet Elite-4i User Guide
27