Table of Contents
Advertisement
Cybernet Elite-4i User Guide
AC97 AUDIO
Select Enabled to support AC97 Audio.
Setting Options: Enabled, Disabled.
4.4.4.3 ON-BOARD SUPER I/O DEVICE Sub Menu
POWER ON Function
x KB Power ON Password
x Hot Key Power ON
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
x UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
x ECP Mode use DMA
PWRON After PWR-Fail
Game Port Address
Midi Port Address
Midi Port IRQ
áâßà Move Enter:Select +/-/PU/PD:Value F10:Save
F5: Previous Values
Figure 41 Onboard Super I/O Device Screen
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If your system has no floppy disk drive,
select Disabled in this field. The default setting is Enabled.
Setting Options: Enabled, Disabled.
Onboard Serial Port 1/ Port 2
Select an address and corresponding interrupt for the first and second serial ports.
The default setting for Port 1 is 3F8/IRQ3, for Port 2 is 2F/IRQ3.
Setting Options: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Auto.
UART Mode Select
The default setting is Normal.
UR2 Duplex Mode
46
Phoenix – AwardBIOS CMOS Setup Utility
Super IO Device
[Button Only]
Enter
Ctrl-F1
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
Half
[378/IRQ7]
[SPP]
3
[Off]
[201]
[330]
[10]
F6: Fail-safe defaults
Item Help
Menu Level >
ESC:Exit F1:General Help
F7:Optimized Defaults
C M O S S e t u p U t i l i t y
Advertisement
Table of Contents
