Installing Peripheral Devices; Installing An Ide Hard Disk Drive; Figure 23 Installing The Hard Disk Drive Into Mounting Frame - Cybernet Elite-4i User Manual

Keyboard computer

Table of Contents

Cybernet Elite-4i User Guide

3.5

Installing Peripheral Devices

An 80-wired IDE drive ribbon cable supports the Ultra ATA format hard disk drive.

This hard drive can be any capacity as long as it matches the 3.5" form factor of the

Elite-4i hard drive mounting frame. Consult the documentation that came with your

IDE drive for details on jumper locations and settings. You must orient the cable

connector so that the pin 1 red edge of the cable corresponds to pin 1 of the IDE

connector.

Remove the two screws at the front of the hard disk drive frame with a

Phillips screwdriver to free the hard disk drive frame from the case.

Insert the hard disk drive into the frame using the flathead Phillips screws

provided.

Connect the 80-pin ribbon cable connector to the hard disk drive.

Connect the 4-wire power cable to the left side of the hard disk drive.

While replacing the hard disk drive frame, push out on the rear panel around

the DC IN connector to install the unit through the rear panel.

H a r d w a r e I n s t a l l a t i o n

Table of Contents