On-Chip Ide Device Sub Menu; Figure 39 Onchip Ide Device Screen - Cybernet Elite-4i User Manual

Cybernet Elite-4i User Guide

4.4.4.1 ON-CHIP IDE DEVICE Sub Menu

IDE HDD Block Mode
On-Chip Primary PCI IDE
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
On-Chip Secondary PCI IDE
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
** On-Chip Serial ATA Setting **
On-Chip Serial ATA
x Serial ATA Port0 Mode
Serial ATA Port1 Mode
áâßà Move Enter:Select +/-/PU/PD:Value F10:Save
F5: Previous Values
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector
read/write. If your IDE hard disk drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal number of block read/writes
per sector the drive can support. The default setting is Enabled.
Setting Options: Enabled, Disabled.
On-Chip Primary / Secondary PCI / IDE
This chipset contains an internal PCI IDE interface with support for two IDE
channels. If Disabled is selected, none of the fields below can be selected for
alteration. The default setting is Both.
Setting Options: Disabled, Primary, Secondary, Both.
IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input / Output) fields let you set a PIO mode (0-4)
for each of the four IDE devices that the onboard IDE interface supports. Modes 0
through 4 provide successively increased performance. In Auto mode, the system
automatically determines the best mode for each device.
The default setting is AUTO.
44
Phoenix – AwardBIOS CMOS Setup Utility
OnChip IDE Device
[Enabled]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
[Disabled]
Primary Master
Primary Slave
F6: Fail-safe defaults

Figure 39 OnChip IDE Device Screen

Item Help
Menu Level >
If your IDE hard drive
supports block mode select
Enabled for automatic
detection of
the optimal number of
block read/writes per sector
the drive can support
ESC:Exit F1:General Help
F7:Optimized Defaults
C M O S S e t u p U t i l i t y