Pos Y-Cable (Option); Figure 16 Dvi Plate; Figure 17 Pos Y-Cable Figure 18 Jp2 Jumper Location - Cybernet Elite-4i User Manual

Cybernet Elite-4i User Guide

2.6.4 POS Y-Cable (option)

This Y-type cable is dedicated for POS (point of sale) application, connects the
two-wired side of the POS-Y cable to the POS port, connect the other two ends to the
POS device (i.e. bar code reader or numeric keypad)
Figure 17 POS Y-Cable
NOTE: In addition to utilizing the POS Y-Cable, the POS port must be
Enabled using two jumpers on the motherboard at location JP2. These
must be set to position 3-5 and 4-6 to Enable the POS port.
16

Figure 16 DVI Plate

Figure 18 JP2 Jumper Location
S y s t e m O v e r v i e w