Table of Contents
Advertisement
Cybernet Elite-4i User Guide
3.7
Connecting the System Fan, Power
Supply and Power Adapter
3.7.1. Connecting the System Fan
There is a fan connector on the Elite-4i Motherboard for the system fan. The
connector supports fans of 12V DC/500mA (six watts) or less. When the system
goes into sleep mode, the fan will shut down to reduce power consumption.
You may replace the case fan as follows:
1.
Disconnect the system fan connector wire at JN5 location on the
Motherboard.
2.
Remove the 4 Phillips screws and slide the system fan up and out of the slot.
3.
Slide in the new system fan, replace the four Phillips screws and connect the
system fan wire to the JN5 connector on the Motherboard.
NOTE: The unit ships with this fan installed and already connected.
28
Figure 30 Installing the System Fan
H a r d w a r e I n s t a l l a t i o n
Advertisement
Table of Contents
